Panel Specifications

The Polypool panel is produced using our up-to-the-minute injection machining process. 

A combination of chemicals are mixed to produce the resin component Isofoam which is then heated to an ambient temperature of around 22C and then injected under pressure in between steel sheets within a mould.

Description

Isofoam RM DP6312ZM is the resin component of a two part, MDI based system for producing rigid foam by pour in place or moulded techniques. Designed for use on both high and low-pressure dispensing equipment.

Application

Isofoam RM DP6312ZM was specially formulated to produce rigid polyurethane (PUR) foam for use on high or low pressure machines.

Typical physical properties

The physical properties opposite were obtained from laboratory produced mouldings (30cm x 30cm x 5cm) at a mix ratio of 42.6 res/57.4 Iso by weight. Component temperatures were at 20℃ and mould temperature at 40℃

Properties
Test Method
Units 		Value
Density (overall) BS4370 Kgm-3 50.5
Density (core) BS4370 Kgm-3 46.1
Thermal conductivity @ 24℃ mean temp Anacon ASTM C-518 Wm-1K-1 (initial) 0.024
Close cell content ASTM D-6226 % 96.4
Compressive Strength  
Parallel to rise BS4370 kPa 223
Perpendicular to rise BS4370 kPa 315
Dimensional Stability, max volume charge  
24 hrs @ +100℃ ASTM D2126 % -2.22